Cisco 350 Series Administration Manual page 262
Managed switches
Hide thumbs
Also See for 350 Series:
- Hardware installation manual (96 pages) ,
- Quick start manual (61 pages) ,
- Manual (10 pages)
Table of Contents
Advertisement
Smartport
Configuring Smartport Using The Web-based Interface
STEP 3
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
-
Enable—Select to enable Auto Smartport on the device.
-
Enable by Auto Voice VLAN—This enables Auto Smartport, but puts it in operation
only when Auto Voice VLAN is also enabled and in operation. Enable by Auto
Voice VLAN is the default.
•
Operational Auto Smartport—Displays the Auto Smartport status.
•
Auto Smartport Device Detection Method—Select whether incoming CDP, LLDP, or
both types of packets are used to detect the Smartport type of the attaching device(s). At
least one must be checked in order for Auto Smartport to identify devices.
•
Operational CDP Status—Displays the operational status of CDP. Enable CDP if Auto
Smartport is to detect the Smartport type based on CDP advertisement.
•
Operational LLDP Status—Displays the operational status of LLDP. Enable LLDP if
Auto Smartport is to detect the Smartport type based on LLDP/LLDP-MED
advertisement.
•
Auto Smartport Device Detection—Select each type of device for which Auto
Smartport can assign Smartport types to interfaces. If unchecked, Auto Smartport does
not assign that Smartport type to any interface.
Click Apply. This sets the global Smartport parameters on the device.
Type Settings
Use the Smartport Type Settings page to edit the Smartport Type settings and view the Macro
Source.
By default, each Smartport type is associated with a pair of built-in Smartport macros. See
Smartport Types
for further information on macro versus anti-macro. Alternatively, you can
associate your own pair of user-defined macros with customized configurations to a Smartport
type. User-defined macros can be prepared only through CLI. You should refer to the CLI
reference guide for details.
Built-in or user-defined macros can have parameters. The built-in macros have up to three
parameters.
Editing these parameters for the Smartport types applied by Auto Smartport from the
Smartport Type Settings page configures the default values for these parameters. These
defaults are used by Auto Smartport.
11
207
Hide quick links:
Advertisement
Table of Contents
