Chapter 11: Port Management; Workflow - Cisco 350 Series Administration Manual

Port Management

Workflow

Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
This section describes port configuration, link aggregation, and the Green Ethernet feature.
It covers the following topics:
• Workflow
• Port Settings
• Error Recovery Settings
• Loopback Detection Settings
• Link Aggregation
• UDLD
• PoE
• Green Ethernet
To configure ports, perform the following actions:
1. Configure port by using the
2. Enable/disable the Link Aggregation Control (LAG) protocol, and configure the potential
member ports to the desired LAGs by using the
LAGs are empty.
3. Configure the Ethernet parameters, such as speed and auto-negotiation for the LAGs by
using the LAG Settings
4. Configure the LACP parameters for the ports that are members or candidates of a dynamic
LAG by using the LACP
5. Configure Green Ethernet and 802.3 Energy Efficient Ethernet by using the
Port Settings page.
page.
page.
LAG Management page. By default, all
10
Properties page.
160