Basic Parameter 3 - Mitsubishi Electric MELSEC iQ-F Series FX5 User Manual

17.10

Basic Parameter 3

This section describes the basic parameter 3 of the positioning module. The storage location of module extension parameters
can be changed with the basic parameter 3. The basic parameter 3 can be changed only with "Module Parameter" in GX
Works3.
For the setting method, refer to the following.
Page 312 Basic setting
Extended parameter storage setting
Set the storage location for module extension parameters. The setting is the same for all the axes.
Extended parameter storage setting
CPU
Positioning module
17 DATA USED FOR POSITIONING CONTROL
474
17.10 Basic Parameter 3
Description
The module extension parameters stored in the CPU module are used.
• When the power is turned on or the CPU module status is changed from STOP to RUN, the module
extension parameters in the module extension parameter file stored in the CPU module are reflected to
the buffer memory.
• At the module data backup or module data initialization, the parameters are reflected to the module
extension parameter file stored in the CPU module.
The module extension parameters stored in the positioning module are used.
• When the power is turned on, the module extension parameters in the module extension parameter file
stored in the positioning module are reflected to the buffer memory. When the CPU module status is
changed from STOP to RUN, the value just before the status change is held.
• At the module data backup or module data initialization, the parameters are reflected to the module
extension parameter file stored in the positioning module.