Mitsubishi Electric MELSEC iQ-F Series FX5 User Manual page 240

Invalidating the software stroke limit
To invalidate the software stroke limit, set a single value in both [Pr.12] Software stroke limit upper limit value and [Pr.13]
Software stroke limit lower limit value and write them to the positioning module. (Set a value within the setting range.)
(To invalidate only the manual operation, set "1: Software stroke limit invalid" in [Pr.15] Software stroke limit valid/invalid
setting.)
The settings are validated at the rising edge (when turned off and on) of [Cd.190] PLC READY signal.
When the unit is degree, the software stroke limit check is not performed during the speed control (including the speed-
position switching control and position-speed switching control) or during the manual control regardless of the values set in
[Pr.12], [Pr.13], and [Pr.15].
• Parameters are set for each axis.
• Setting the parameters using GX Works3 is recommended. To perform the setting using programs, many
programs and devices are required. The execution becomes complicated, and the scan times will increase.
Setting when the control unit is degree
■Current value address
The address of [Md.20] Current feed value is a ring address from 0 to 359.99999°.
359.99999°
0° 0°
■Setting the software stroke limit
The upper/lower limit values of the software stroke limit are between 0 and 359.99999º.
To validate the software stroke limit, set the upper limit value in the clockwise direction from the lower limit value.
Lower limit
315°
Section A
Section B
To set the section A or B as the movement range, set the following values.
Section set as the movement range Software stroke limit lower limit value
Section A
Section B
12 CONTROL SUB FUNCTION
238
12.4 Function to Limit Control
359.99999°
0°
Set in a clockwise direction
Upper limit
90°
315.00000°
90.00000°
Software stroke limit upper limit value
90.00000°
315.00000°