14
PARAMETER SETTING
This chapter describes the parameter setting of the positioning module. By setting parameters, the parameter setting by
program is not needed.
The parameter setting has two types including the module parameter and module extension parameter.
14.1
Parameter Setting Procedure
1.
Add the positioning module in GX Works3.
[Navigation] [Parameter] [Module Information] Right-click [Add New Module]
2.
The parameter setting has two types including the module parameter and module extension parameter. Select either of
them from the tree on the following window.
[Navigation] [Parameter] [Module Information] [Target module]
3.
Write the settings to the CPU module using GX Works3.
[Online] [Write to PLC]
4.
The settings are reflected by resetting the CPU module or powering off and on the system.
14 PARAMETER SETTING
14.1 Parameter Setting Procedure
14
311