Mitsubishi Electric MELSEC iQ-F Series FX5 User Manual page 324

M code comment edit
Set comments for M codes. The set comments are saved in a project.
■Setting method
Offline Simulation
Offline simulations enable simulation of operation (waveforms) of configured positioning data.
■Setting method
The following control methods are available for use with Offline Simulation.
• 01H: ABS1 1-axis linear control (ABS)
• 02H: INC1 1-axis linear control (INC)
• 03H: FEED1 1-axis fixed-feed control
• 0AH: ABS2 2-axis linear interpolation control (ABS)
• 0BH: INC2 2-axis linear interpolation control (INC)
• 0CH: FEED2 Fixed-feed control by 2-axis linear interpolation
• 0DH: ABS Circular interpolation control with sub point specified (ABS)
• 0EH: INC Circular interpolation control with sub point specified (INC)
• 0FH: ABS. Circular interpolation control with center point specified (ABS, CW)
• 10H: ABS. Circular interpolation control with center point specified (ABS, CCW)
14 PARAMETER SETTING
322
14.3 Module Extension Parameter
1.
Double-click "M code comment edit" in "Axis 
Positioning data".
2.
Input an M code number for which a comment is set in
"M Code" in the range of 1 to 65535. The maximum
number of M codes for which comments can be set is
50.
3.
Input a comment in "M Code Comment".
4.
Click the [OK] button.
1.
Double-click on "Offline Simulation" for the "Axis 
Positioning Data".
2.
Set "Positioning Data No." to the positioning data
number corresponding to the waveform you want to
display.
3.
The waveform corresponding to the positioning data
setting appears.