Table of Contents
Advertisement
uuLocking and Unlocking the DoorsuLocking/Unlocking the Doors from the Outside
156
To temporarily deactivate the function:
1. Set the power mode to OFF.
2. Open the driver's door.
3. Using the master door lock switch, operate
the lock as follows:
Lock
Unlock
Lock
Unlock.
u
The beeper sounds and the function is
deactivated.
To restore the function:
• Set the power mode to ON.
• Lock the vehicle without using the auto lock
function.
• With the smart entry remote on you, move
out of the auto lock function operation
range.
• Open any door.
1Locking the doors and tailgate (Walk away auto lock®)
Under the following circumstances, the auto lock
function will not activate:
•
The remote is inside the vehicle.
uThe beeper will not sound.
•
The remote is taken out of its operational range
before all doors and tailgate are closed.
uThe beeper will sound.
Models with power tailgate
If equipped, the user must wait until the power
tailgate fully closes before the auto lock function will
be activated.
The auto lock function does not operate when any of
the following conditions are met.
•
The smart entry remote is inside the vehicle.
•
A door, tailgate or the hood is not closed.
•
The power mode is set to any mode other than OFF.
•
The smart entry remote is not located within a
radius of about 5 feet (1.5 m) from the vehicle
when you get out of the vehicle and close the
doors and tailgate.
Auto lock function operation stop beeper
After the auto lock function has been activated, the
auto lock operation stop beeper sounds for
approximately two seconds in the following cases.
•
The smart entry remote is put inside the vehicle
through a window.
•
You are located too close to the vehicle.
•
The smart entry remote is put inside the tailgate.
If the warning beeper sounds, check that you are
carrying the smart entry remote. Then, open/close a
door and confirm the auto lock activation beeper
sounds once.
Advertisement
Table of Contents
