Installing The Dos Ndis2 Driver Software On The Hard Disk - D-Link DGE-560SX User Manual

device=a:\net\ifshlp.sys
lastdrive=z
3.3.3 Installing the DOS NDIS2 Driver Software on
the Hard Disk
To install the DOS NDIS2 Driver Software on the hard disk
1. Verify that the system has Microsoft LAN Manager 2.2 installed, with a protocol such
as NetBEUI configured.
2. Create a folder on your hard disk to store the NDIS 2.01 driver.
Example: C:\LANMAN
3. Copy the B57.dos file to this folder.
4. Edit the Config.sys file by adding the following lines:
DEVICE = C:\LANMAN\PROTMAN.DOS
DEVICE = C:\LANMAN\B57.DOS
DEVICE = C:\LANMAN\NETBEUI.DOS
5. Edit the Autoexec.bat file by adding the following lines:
C:\LANMAN\NETBIND.EXE
C:\LANMAN\NET START WORKSTATION
C:\LANMAN\NET USE
6. Edit the Protocol.ini file (located in C:\LANMAN) to configure the driver to bind with
NetBEUI or any other protocols.
Example:
[PROTOCOL MANAGER]
DriverName = PROTMAN$
[NETBEUI_XIF]
DriverName = netbeui$
BINDINGS = B57
[B57]
DriverName = "B57$"
7. Restart the computer to complete the installation.
drive letter server name
: \\
31
D-Link DGE-560SX User Guide
resource name
\