Adding Vlans To Teams; Snmp Management - D-Link DGE-560SX User Manual

#2 and #2 belong to VLAN #2 only, and are logically in the same IP subnet as
the Main Server and PC #5. The switch port connected to this segment has
tagging turned off.
PC #3 A member of VLAN #1, PC #3 can communicate only with the Main Server
and PC #5. Tagging is not enabled on PC #3 switch port.
PC #4 A member of VLAN #3, PC #4 can only communicate with the servers.
Tagging is not enabled on PC #4 switch port.
PC #5 A member of both VLANs #1 and #2, PC #5 has an Broadcom adapter
installed. It is connected to switch port #10. Both the adapter and the switch
port are configured for VLANs #1 and #2 and have tagging enabled.
NOTE: VLAN tagging is only required to be enabled on switch ports that create trunk links
to other switches, or on ports connected to tag-capable end-stations, such as servers or
workstations with Broadcom adapters.

1.3.2 Adding VLANs to Teams

Each team supports up to 64 VLANs (63 tagged and 1 untagged). Note that only Broadcom
®
adapters and Alteon
VLANs on an adapter, a server with a single adapter can have a logical presence on multiple
IP subnets. With multiple VLANs in a team, a server can have a logical presence on multiple
IP subnets and benefit from load balancing and failover. For instructions on adding a VLAN to
a team, see Adding a VLAN for Windows operating systems or see Configuring VLANs for
NetWare operating systems.
NOTE: Adapters that are members of a failover team can also be configured to support
VLANs. Because VLANs are not supported for an Intel LOM, if an Intel LOM is a member of a
failover team, VLANs cannot be configured for that team.

1.4 SNMP Management

BASP Subagent
The BASP subagent, baspmgnt.dll, is designed for the Windows Server 2003, and Windows
Server 2008 SNMP service. It is required to install the SNMP service before installing the
BASP subagent.
AceNIC adapters can be part of a team with VLANs. With multiple
D-Link DGE-560SX User Guide
14