Deleting A Vlan - D-Link DGE-560SX User Manual

1. Select one of the listed VLANs.
2. Click the Information tab to view the properties of the VLAN adapter.
3. Click the Statistics tab to view the statistics for the VLAN adapter.
4. Click the Diagnostics tab to run a network test on the VLAN adapter.

Deleting a VLAN

The procedure below applies when you are in Expert Mode.
To delete a VLAN
1. Select the VLAN to delete.
2. From the Teams menu, select Remove VLAN.
3. Click Apply.
4. Click Yes when the message is displayed indicating that the network connection will
be temporarily interrupted.
Note: If you delete a team, any VLANs configured for that team are also deleted.
Configuring LiveLink for a Smart Load Balancing and Failover and SLB
(Auto-Fallback Disable) Team
LiveLink is a feature of BASP that is available for the Smart Load Balancing (SLB) and SLB
(Auto-Fallback Disable) type of teaming. The purpose of LiveLink is to detect link loss beyond
the switch and to route traffic only through team members that have a live link.
Read the following notes before you attempt to configure LiveLink.
NOTES:
Before you begin configuring LiveLink™, review the description of LiveLink.
o
Also verify that each probe target you plan to specify is available and working.
If the IP address of the probe target changes for any reason, LiveLink must
be reconfigured. If the MAC address of the probe target changes for any
reason, you must restart the team (see "Troubleshooting").
A probe target must be on the same subnet as the team, have a valid (not a
o
broadcast, multicast, or unicast), statically-assigned IP address, and be
highly available (always on).
D-Link DGE-560SX User Guide
123