D-Link DGE-560SX User Manual page 52

Disables the interrupt driven mode. When set to Poll=1, the driver does not use interrupts,
but is polled by the NetWare operating system. This is a common feature supported in
NetWare. The poll mode may increase driver performance in some environments.
0 = OFF (default)
1 = ON
Wirespeed=
Provides adapter link and data integrity even if the adapter is attached to a questionable
cable and/or switch. For example, an adapter that is trying to connect at 1000 Mbit/s on a
Category 3 cable ordinarily would not link. With Wirespeed= set to 1, the link is made at 100
Mbit/s.
0 = OFF
1 = ON (default)
Model=
Allows the addition of a subsystem ID of a specific adapter so that the driver loads only on the
first adapter found with a matching subsystem ID. For example, Model=0x14E4. The default
value is 0
Fiber=
The driver has support for the 1000FD fiber adapter. The fiber auto-negotiates link with a
fiber switch even though it only supports 1000FD. In some cases, the user may want to force
the adapter to 1000FD.
AUTO (default)
FORCE
NOTE: If you modify any of the adapter properties, you must reboot the system before the
changes take effect. If you make changes and do not reboot, you may experience problems.
A valid Autoexec.ncf file is shown below. One set of load and bind commands (in bold) is
added for each frame type the adapter is configured to support.
D-Link DGE-560SX User Guide
52