D-Link DGE-560SX User Manual page 49

Max = 5000000 (5 seconds)
Units are in microseconds. The default value is 200.
TxPacketsPer=
Enables allowing an interrupt to occur after a specific amount of packets is transmitted.
Min = 0 (disabled)
Max = 100
The default value is 20.
RxPacketsPer=
Enables allowing an interrupt to occur after a specific amount of packets is received.
Min = 0 (disabled)
Max = 100
The default value is 75.
CheckSum=
Enables or disables the transmit and receive checksum offload feature. Checksum offload
support is only for TCP/IP packets; therefore, the default setting for checksum offload is OFF.
OFF
ON
TX
RX
TxFlow=
This keyword allows enabling/disabling of transmit flow control.
ON
D-Link DGE-560SX User Guide
49