Hot Standby; Configuring Vlans - D-Link DGE-560SX User Manual

adapters. For example, ETHERNET_802.2 can be loaded in BASP VSLOT 1 if
ETHERNET_802.2 is loaded for the B57 driver in SLOT 1 and 2 in the example below. Similarly,
a virtual adapter can only be bound to a physical adapter if the physical adapter has all the
frame types loaded in the virtual adapter.
Example:
LOAD ODINEB.NLM
LOAD BASP.LAN FRAME=ETHERNET_802.2 NAME=BASP_1_E82 VSLOT=1
LOAD B57.LAN FRAME=ETHERNET_802.2 NAME=B57_1_E82 SLOT=1
LOAD B57.LAN FRAME=ETHERNET_802.2 NAME=B57_2_E82 SLOT=2

Hot Standby

For a Smart Load Balancing™ (SLB) type of team, only one adapter can be designated as a
hot standby member. Use the keyword standby in the BASP bind command to bind an
adapter as a hot standby member.
Example:
BASP BIND BASP_1_EII B57_1_EII
BASP BIND BASP_1_EII B57_2_EII STANDBY
In the above example, B57_1_EII and B57_2_EII are bound as primary and hot standby
members, respectively. Note that a standby member can be used only on a Smart Load
Balancing type of team.
NOTE: No traffic is passed to the standby member until the primary member fails

Configuring VLANs

NOTES:
VLANs are not supported on non-Broadcom adapters. VLANs are supported
o
on the Alteon adapters if the ALT.LAN driver provided by Broadcom is used. If
a non-Broadcom adapter is a member of a failover team, VLANs are not
supported for that team.
To avoid failover problems when using BASP, make sure that the spanning
o
tree is disabled on the switch to which the network adapter is connected.
To add VLANs to a team, do the following:
D-Link DGE-560SX User Guide
61