Epson RC180 Manual page 219

No. Message
3234 Port number was not specified.
3235 String type variable was not specified.
RS-232C port
3236
specified.
Network communication port number
3237
was not specified.
Communication
3238
specified.
3239 Data bit number was not specified.
3240 Stop bit number was not specified.
3241 Parity was not specified.
3242 Terminator was not specified.
3243 Hardware flow was not specified.
3244 Software flow was not specified.
3245 None was not specified.
RC180 Rev.17
Port number that indicates the file or
communication port is not specified in
Read, ReadBin, Write, and WriteBin
statements.
Refer to SPEL+ Language Reference
"Read Statement" and specify a proper
file number or port number.
String type variable is not specified in
the command that requires specification
of string type variable as a parameter.
Specify a valid string type variable.
RS-232C port number is not specified in
OpenCom,
number was not
statements. Refer to SPEL+ Language
Reference "OpenCom Statement" and
specify a proper port number.
Network communication port number is
not specified in OpenNet, CloseNet,
SetNet,
Specify an integer from 201 to 216.
Communication speed (baud rate) is not
specified in SetCom statement.
speed was not
to SPEL+ Language Reference "SetCom
Statement" and specify a proper baud
rate.
Data bit length is not specified in
SetCom statement.
Language
Statement" and specify a proper data bit
length.
Stop bit length is not specified in
SetCom statement.
Language
Statement" and specify a proper stop bit
length.
Parity is not specified in SetCom
statement.
Reference "SetCom Statement" and
specify a proper parity.
Terminator (end of send/receive line) is
not specified in SetCom and SetNet
statements. Refer to SPEL+ Language
Reference "SetCom Statement" and
specify a proper terminator.
Hardware flow is not specified in
SetCom statement.
Language
Statement" and specify a proper flow
control.
Software flow is not specified in SetCom
statement.
Reference "SetCom Statement" and
specify a proper flow control.
"NONE" is not specified for software
flow control setting in SetNet statement.
Specify "NONE".
Maintenance 8. Trouble Shooting
Remedy
CloseCom, and SetCom
and WaitNet statement.
Refer
Refer to SPEL+
Reference "SetCom
Refer to SPEL+
Reference "SetCom
Refer to SPEL+ Language
Refer to SPEL+
Reference "SetCom
Refer to SPEL+ Language
Note 1 Note 2
207