Gantry; Temperatures; Temperature Limits - HP Designjet 3D Service Manual

Gantry

The gantry controls the adjustment for the XY gantry. These values are set in
the factory and do not need to be adjusted unless the XY gantry is adjusted
or replaced where part based calibration is required.
Calibration" on page 343.

Temperatures

The temperature control dialog allows you to adjust the set points for the
head and chamber temperatures, for both modeling and at standby. These
are set at the factory and should only be changed if noted to be incorrect.
Temperature
Head
Support
Chamber

Temperature Limits

Temperature
Head
Support
Chamber
Building Set Point
◦
310
C
◦
310
C
◦
77
C
Min.
89.5
89.5
40
See "Part Based
Standby Set Point
◦
100
C
◦
100
C
◦
77
C
Max
333
333
77
-428