HP Designjet 3D Service Manual page 299

Figure 245: Left side access panel mounting screw locations
Remove the 7
mounting screws.
5
5. Using a ⁄ " nut driver or standard screwdriver, remove the right side
16
access panel mounting screws and remove the right side access panel.
See Figure 246.
Figure 246: Right side access panel mounting screw locations
Remove the 7
mounting screws.
6. Remove the toggle head assembly. See
assembly" on page 212
7. Remove the head board. See
8. Remove the TC Amp board. See
page 239
9. Cut the wire tie from the umbilical hose. See
"Removing the toggle head
"Removing the head board" on page 233
"Removing the TC Amp board" on
Figure 247.
-283