Removing The Ac Input; Installing The Ac Input - HP Designjet 3D Service Manual

Removing the AC Input

1. Open the electronics bay. See
2. Touch the metal plate of the electronics bay cover to discharge any static
3. Remove the LF-G (green) spade connector. See
4. Remove the LF-N (white) spade connector. See
5. Remove the LF-P (black) spade connector. See
LF-G (green)
6. Using a Phillips screwdriver, remove the 2 mounting screws and remove

Installing the AC Input.

1. Install the 2 AC Input mounting screws with a Phillips screwdriver.
2. Connect the LF-P (black) spade connector.
3. Connect the LF-N (white) spade connector.
4. Connect the LF-G (green) spade connector.
5. Close the electronics bay. See
-198
page 171
electricity.
Figure 1 14: AC input connection locations
the AC Input. See Figure 1 15.
Figure 1 15: AC input mounting screw locations
Remove the mounting screws
page 172
"Opening the electronics bay" on
Figure 1 14.
Figure 1 14.
Figure 1 14.
"Closing the electronics bay" on
LF-N (white)
LF-P (black)