Remove the 3
mounting screws
8. Gently pull the I/O card out from the power distribution board sockets.
Installing the I/O card
1. Gently slide the I/O card in to the power distribution board sockets.
2. Verify the I/O card is seated properly by viewing the connection
3. Using a Phillips screwdriver, reinstall the 3 mounting screws.
4. Reconnect the thermocouple to the back side of the I/O card.
5. Reconnect the 6 cables to the I/O card.
6. Close the electronics bay. See
7. Reinstall the side panels. See
8. Reinstall the top panel. See
-186
Figure 98: I/O card mounting screw locations
through the viewing slots. See
Figure 99: I/O card viewing slot location
I/O card
connections
page 172
Figure 99.
"Closing the electronics bay" on
"Installing the side panels" on page 164
"Installing the top panel" on page 162