Installing the TC Amp board
1. Align the TC Amp board with the mounting holes.
1
2. Using a
⁄
" nut driver or standard screwdriver, reinstall the 3 mounting
4
screws.
3. Reconnect the model and support thermocouple wires.
4. Reconnect the umbilical cable.
5. Reinstall the right side access panel.
6. Reinstall the side panels. See
7. Reinstall the top panel. See
Umbilical Hose
Required Tools
5
•
⁄
" nut driver or standard screwdriver
16
1
•
⁄
" nut driver
4
5
•
⁄
" allen wrench
32
•
Cutters
Hardware
•
Wire tie
3
•
10-32 x
⁄
" slotted screws (x7)
8
1
1
•
⁄
- 20 x
⁄
" button head cap screws (x2)
4
2
Removing the umbilical hose
1. Remove the top panel. See
2. Remove the side panels. See
3. Remove the upper electronics bay cover. See
tronics bay cover" on page 173
5
4. Using a
⁄
" nut driver or standard screwdriver, remove the right side
16
access panel mounting screws and remove the panel. See
"Installing the side panels" on page 164
"Installing the top panel" on page 162
"Removing the top panel" on page 161
"Removing the side panels" on page 162
"Removing the upper elec-
Figure 185.
-241