Z Motor; Removing The Z Motor - HP Designjet 3D Service Manual

Z Motor

Required Tools
5
• ⁄ " nut driver or standard screwdriver.
16
3
• ⁄ " allen wrench.
32
9
• ⁄ " allen wrench.
64
• Cutters
Hardware
• Wire ties (x2)
3
• 10-32 x ⁄ " slotted screws (x4)
8
1
• 4-40 x ⁄ " slotted screws (x8)
4
• #4 Splitlock washer (x4)
• #4 SAE washer (x4)

Removing the Z motor

1. Remove the top panel.
2. Remove the side panels. See
3. Remove the upper electronics bay cover. See
tronics bay cover" on page 173
4. Remove the electronics bay. See
page 175
5
5. Using a ⁄ " nut driver or standard screwdriver, remove the 4 Z stage
16
panel mounting screws and remove the Z stage panel. See
See"Removing the top panel" on page 161
"Removing the side panels" on page 162
"Removing the upper elec-
"Removing the electronics bay" on
Figure 302.
-321