Rough surface quality
Characteristics: Sides of part are rough or over filled, with little or no part
shift.
Corrective actions:
1. STL wall thickness is too thin. Verify proper wall thickness.
2. Reprocess the part using the latest version of HP Designjet 3D Software
Solution software and check STL report for errors.
3. Check for STL errors in CAD software.
4. Replace the tip shrouds.
5. Loose tips screws, tighten the screws.
6. Replace the tips.
7. Deformed toggle spring, replace the toggle spring.
8. Check X/Y guide rods for loose hardware. Replace XY table as needed.
-146