Head Board; Removing The Head Board - HP Designjet 3D Service Manual

Head Board

Required tools
5
• ⁄ " nut driver or standard screwdriver
16
1
• ⁄ " nut driver
4
Hardware
3
• 10-32 x ⁄ " slotted screws (x7)
8
1
• 6-32 x ⁄ " slotted screws (x6)
4

Removing the head board

1. Remove the top panel. See
2. Remove the side panels. See
5
3. Using a ⁄ " nut driver or standard screwdriver, remove the right side
16
access panel mounting screws and remove the panel. See
Figure 168: Right side access panel mounting screw locations
Remove the 7
mounting screws.
4. Remove the head cover by pressing the tabs and pulling the cover out-
ward. See Figure 169.
"Removing the top panel" on page 161
"Removing the side panels" on page 162
Figure 168.
-233