Thermal Fuses; Removing The Right Side Thermal Fuse - HP Designjet 3D Service Manual

Thermal Fuses

Required Tools
5
• ⁄ " nut driver or standard screwdriver.
16
Hardware
3
• 10-32 x ⁄ " slotted screws (x8)
8
1
• 4-40 x ⁄ " slotted screws (x4)
4

Removing the right side thermal fuse

1. Remove the top panel. See
2. Remove the side panels. See
5
3. Using a ⁄ " nut driver or standard screwdriver, remove the 4 mounting
16
screws and remove the right side heater panel. See
Figure 294: Right side heater panel mounting screw locations
Remove the 4
mounting screws
4. Disconnect the RTH1 and RTH2 spade connectors by pulling outward.
See Figure 295.
"Removing the top panel" on page 161
"Removing the side panels" on page 162
Figure 294.
-315