HP Designjet 3D Service Manual page 370

15. Measure and record the distance from the outside edges of circles F and
16. Measure and record the diameter of circle F along the center line
17. Add the lengths derived from steps 14 and 15 (E-F and F-G) and then
18. Measure and record the distance from the outside edges of circles C
-354
Figure 342: Measuring distances from outside edges of E and F
G. Ensure the caliper is not seated on the small bump of circle G. See
Figure 343
Figure 343: Measuring distances from outside edges of F and G
between E and G. See Figure 344
Figure 344: Measuring diameter of circle F
subtract the width of circle F derived from step 16. Record this total as
"Rear"
and G. Ensure the caliper is not seated on the small bump of circles C or
G. Record this total as "Right", see Figure 345