Installing The Front Panel; Door Solenoid; Removing The Door Solenoid - HP Designjet 3D Service Manual

Installing the front panel

1. Align the front panel with the mounting holes.
2. Using a
3. Using a
4. Reinstall the display panel. See
5. Close the chamber door.

Door Solenoid

Required Tools

Removing the door solenoid

1. Remove the display panel. See
2. Remove the front panel. See
3. Disconnect the door solenoid (DRSOL) cable by pressing down on the
4. Push the solenoid pin out and down to remove from the mounting
-168
5
⁄ " nut driver or standard screwdriver, reinstall the 6 mounting
16
screws.
5
⁄ " nut driver or standard screwdriver, reinstall the 2 mounting
16
screws behind the display panel.
page 166
5
• ⁄ " nut driver or standard screwdriver.
16
page 165
tab. See Figure 74.
Figure 74: Door solenoid connector location
Disconnect the DRSOL cable.
bracket. See Figure 75.
"Installing the display panel" on
"Removing the display panel" on
"Removing the front panel" on page 166