HP Designjet 3D Service Manual page 112

Code Description
14,65 Abort : Find home
failed, X eot not tripped
14,66 Abort : Find home
failed, Y eot not tripped
14,67 Abort : Head
temperature too high
14,68 Abort: Illegal PMD
Command
14,69 Abort: XY PMD Read
Checksum error
14,70 Abort: XY PMD Write
Checksum error
14,71 Abort: Z PMD Read
Checksum error
14,72 Abort: Z PMD Write
Checksum error
14,73 Abort: Head TC Board
Configuration error
14,74 Unexpected contact with
unknown limit.
14,75 Unknown
14,76 Software bug
14,77 Buffer is larger than the
data
14,78 Buffer is smaller than the
data
Corrective Actions
1. Power cycle machine - remember to move
head away from switches.
2. Using LED's check to see home box toggles
when sensor is activated. If not, check
sensor and/or umbilical cable for X , Y
cable for Y.
3. X errors - Check pins and reseat connector
J505 on the I/O Card. Y errors - Check
pins and reseat connector J503 on the I/O
Card.
1. Verify the TC and Liquefier Heaters are
plugged in properly.
2. Check umbilical is connected properly.
3. TC Amp board is bad. Replace TC Amp
Board.
4. Head board is bad. Replace head board.
5. Replace the umbilical cable.
1. If error occurs more than once a month
replace the controller board.
1. If error occurs more than once a month
replace the controller board.
1. If error occurs more than once a month
replace the controller board.
1. If error occurs more than once a month
replace the controller board.
1. If error occurs more than once a month
replace the controller board.
Not used on HP Designjet 3D printers.
1. Power cycle machine - remember to move
head away from switches.
2. Using LED's check to see limit box toggles
when switch is activated. If not, check
switch and/or umbilical cable for X, Y
cable for Y.
3. X errors - Check pins and reseat connector
J505 on the I/O Card. Y errors - Check
pins and reseat connector J503 on the I/O
Card.
No error code associated with an error.
1. Cycle power.
1. Cycle power.
2. Replace single board computer.
3. Replace controller board.
-96