Toggle Head Assembly Installation Checklist - HP Designjet 3D Service Manual

Toggle Head Assembly Installation
Checklist
If you have any questions before or during installation, do not hesitate to call
your Customer Support provider.
Replace the Toggle Head Assembly.
Verify that all electrical leads are connected correctly.
Clean and vacuum the system.
Power system up and verify that head reaches temperature and the
system homes correctly.
Using DataStat or HP Designjet 3D Diagnostic Software enter the Z Tip
to Tip value that came with the head and cycle power.
Load material.
Perform the Z Calibration and XY Offset Calibration.
Run a part to ensure part quality is acceptable and that head is
functioning correctly.
-421