HP Designjet 3D Service Manual page 256

5. Disconnect the model and support thermocouple wires by pulling out-
Disconnect the support
thermocouple
Disconnect the model
thermocouple
6. Using a
-240
Figure 182: Disconnecting the umbilical cable
Disconnect the
umbilical cable
ward. See Figure 183.
Figure 183: Thermocouple wire locations
1
⁄ " nut driver or standard screwdriver, remove the 3 mounting
4
screws and remove the TC Amp board. See
Figure 184: TC Amp board mounting screw locations
Remove the 3
mounting screws
Figure 184.