Tools Needed For Repair Not Order-Able As A Service Part; Tools Needed For Repair That Are Order-Able As A Service Part; Pre-Maintenance Procedures - HP Designjet 3D Service Manual

Tools needed for repair not order-able as a ser-
vice part
1. Standard screwdriver set
2. Phillips screwdriver set
3. Allen wrench set
4. Pliers
5. Channel locks
6. Small wire cutters
7. Needle nose pliers
8. Assorted wire ties
9. Box wrenches
10. Flashlight
1 1. Grounding strap
12. Voltmeter
13. Network crossover cable (for communication testing)
14. Laptop computer
15. Nut driver set
16. Dial indicator
17. Serial data cable (for issuing Tera Term commands)
Tools needed for repair that are order-able as a
service part
1. Belt tension gauge (for adjusting XY table drive belts)
2. Y-Motor belt tensioning tool (for adjusting belt Y table motor belt)
3. Head dial indicator bracket (for XY table and Z stage leveling)
4. Spring Removal Tool
5. Drive Wheel Alignment Rod
6. Set of Shims (Feeler Gauges)
7. Liquefier Alignment Rod
8. Filament Guide Alignment Rod (For SST Only)
9. Service Guide (CD and Hardcopy)
10. HP Designjet 3D Diagnostic Software CD
1 1. HP Designjet 3D Software Solution CD
12. Firmware CD

Pre-Maintenance Procedures

1. Unload model and support material.
2. Power the printer down using the power switch.
3. After the printer has powered down, turn the main power toggle switch
4. Remove the AC power cord, RJ-45 network cable and UPS cable (if
-160
off on the back of the unit.
used) from the back of the unit.