Installing The Y Home Sensor; Y Eot (End Of Travel) Sensor; Removing The Y Eot Sensor - HP Designjet 3D Service Manual

4. Remove the Y home sensor.

Installing the Y Home Sensor

1. Align the Y Home Sensor with the mounting hole.
2. Using a
3. Reconnect the Y Home cable.
4. Install the top panel. See

Y EOT (End of Travel) Sensor

Required Tools
Hardware

Removing the Y EOT sensor

1. Remove the top panel. See
2. Disconnect the Y EOT cable by pressing in on the tab and pulling out-
-250
Figure 197: Y home sensor mounting screw location
1
⁄ " nut driver or standard screwdriver, reinstall the mounting
4
screw.
1
• ⁄ " nut driver or standard screwdriver.
4
3
• 6-32 x ⁄ " slotted screw (x1)
8
ward. See Figure 198.
"Installing the top panel" on page 162
"Removing the top panel" on page 161
Remove the
mounting screw