Installing The 24Vdc Power Supply - HP Designjet 3D Service Manual

Installing the 24VDC power supply

1. Align the 24VDC power supply with the top of the rear panel of the
2. Using a Phillips screwdriver, reinstall the 2 mounting screws to the top of
3. Close the rear electronics bay panel.
4. Using a Phillips screwdriver, reinstall the 2 mounting screws.
5. Reconnect J3 1 through 4 connectors using a Phillips screwdriver.
6. Reconnect J1 on the 24VDC power supply.
7. Close the rear panel of the Electronics Bay.
8. Using a
9. Reinstall the electronics bay. See
10. Reinstall the side panels. See
1 1. Reinstall the top panel. See
-204
electronics bay and the tab to the right of the mounting location. See
Figure 124.
Figure 124: Align the 24VDC power supply
the rear panel.
5
⁄ " nut driver or standard screwdriver, reinstall the 3 mounting
16
screws.
page 176
"Installing the electronics bay" on
"Installing the side panels" on page 164
"Installing the top panel" on page 162