Commissioning
5.7 Parameter reset to factory settings
5.7
Parameter reset to factory settings
The factory settings represent the defined original status of the device on delivery.
Resetting the parameters to the factory settings means that all the parameter settings made
since the system was delivered are reset.
Resetting Parameters via AOP30
Table 5- 4
Parameter reset via STARTER
With STARTER, the parameters are reset in online mode. The required steps are described
below:
Step
Choose
Project > Connect to target system
Click the drive unit whose parameters you want to reset to the factory settings
and click Restore factory settings icon in the toolbar.
254
Procedure for resetting parameters to the factory settings with AOP30
Setting the "Extended" access level on the operator panel
<Key pushbutton> - <Access level> - Set "Extended"
Setting the parameter filter to "Parameter reset"
<MENU> <Commissioning/Service> <Device commissioning>
<OK> <30: Parameter Reset> <OK>
Reset all parameters to factory settings
The factory settings for all the device parameters are restored.
Selection in toolbar
Converter cabinet units
Operating Instructions, 03/2012, A5E03263466A