Siemens SINAMICS G150 Operating Instructions Manual page 216

Commissioning
5.3 Procedure for commissioning via STARTER
Note
Check your options carefully against the options specified on the type plate.
Since the wizard establishes internal interconnections on the basis of the options selected,
you cannot change the selected options by clicking < Back.
If you make an incorrect entry, delete the entire drive unit from the project navigator and
create a new one.
⇒ Check your options carefully and then click Continue >
Selecting the control structure
Figure 5-15
214
Selecting the control structure
Converter cabinet units
Operating Instructions, 03/2012, A5E03263466A