Sharp IV-C35M User Manual page 84

Setting Measurement Conditions
(3) Setting window boundaries (enable/disable)
This function enables and disables the labeling (object identification) of binary images located that
cross over the window frame boundary.
3
Measurement programs which are affected by these settings
BGA/CSP inspection, object counting by binary conversion, object identification by binary
conversion
Setting method
Select "DETAIL" in the upper function menu
on the REG COND screen. Select
"BOUNDARY PROCESS" from the popup
menu and then press the SET key.
(4) Object identification and numbering function (labeling)
Object identification and numbering (labeling) is a process for locating separate object and assigning
serial numbers (labels) one at a time in a binary image. By this process, multiple objects in the same
binary image can be handled separately or as a group.
Measurement programs which are affected by these settings
Object counting by binary conversion, object identification by binary conversion
Window
Binary
conversion
Labeling
(disable window
boundary)
Binary
conversion
3
4
1 2
Labeling
(enable
window
boundaries)
3 4
Images 1 and 3 cross over the
window frame edges and are
measured together with the
areas outside the window frame
edges.
1
Condition: Labeling
2
(in order they are
connected)
REG COND SCREEN COND SAVE DETAIL
1REGISTER NO.
0(0~3)
Object
identification
(in order of
scanning)
3
Object identification
(in order of area)
2
Island
1
3-22
COLOR F C1 BRT
MASK REGIST.
BINARY PROCESS
BINRY NOISE FILT
BOUNDARY PROCESS
AREA FILTER
1
2
Island
4