Sharp IV-C35M User Manual page 321

Communication (General Purpose Serial Interface)
The conditions below are what is shown when the "TRIG CCD START" is selected on the "
INP I/F" on the "I/O CONDITIONS" selection screen.
Measurement
start
Auto
Parallel port
General-purpose
serial port + USB
Cate-
Processing function
gory
Operation lock
status
English or
Japanese display
Object type
number
Image status
Output image
camera
Shutter speed
Time
Initialize all
White balance
Self-diagnostic
Reset
Manual measurement
coordinates
22
Output
selection
Parallel port ---
General purpose Response output from
serial port + USB command code 11
None ---
SHARP/MITSUBISHI/
Computer link
OMRON/YOKOGAWA
General-purpose Response output from
serial port command code 11
--- Command codes 10 to 12 Command codes 10 to 12
Code
Read 50 - Read lock/unlock condition of the operation screen.
Set 51 - Set lock/unlock for the operation screen.
Read 52 - Read the status from the English or Japanese display.
Set 53 - Enter a change on the English or Japanese display.
- Read an object type number to measure when the
Read 54
measurement start input is turned ON.
- Assign an object type number to be executed when the
Set 55
measurement start input is turned ON.
- Read the image status being monitored
Read 56
(Output: Through/freeze, Brightness: Full/half).
- Change the status of the image being monitored
Set 57
(Output: Through/freeze, Brightness: Full/half).
- Read the status of the camera outputting an image for
Read 58
the specified object type.
- Set the status of the camera that is outputting an image
Set 59
for the specified object type.
- Read the shutter speed setting for the specified object
Read 5A
type.
Set 5B - Set shutter speed for the specified object type.
Read 5C - Read the IV-C35M's system time.
- Adjust the IV-C35M's system time to the time
Set 5D
set by the host device.
- Set all settable conditions to their initial values (global
60 conditions, all object type conditions, and reference
images).
67 - Adjust white balance of the image.
- Check the controller for a hardware error.
68 Items to check: VRAM (read after write), SDRAM (read
after write), etc.
69 - Reset the controller (the same as a power reset operation).
Read 70 - Read the coordinates detected by manual measurement.
Set 71 - Set the coordinates for manual measurement.
Serial output Object type change
Parallel
Command code 55
Parallel
Parallel
Parallel
Function
22-2
MEAS