Register And Display Ng Images; How To Register Ng Images - Sharp IV-C35M User Manual

1-8 Register and display NG images

NG image refers to any image that the controller has determined to be unacceptable after making the
measurements.
- NG images are registered in the controller's memory. By replaying the NG images, you can review the
points with problems.
This section describes how to register, display, and initialize NG images.
Item
Register NG images
MAIN OPS
menu
NG images
screen
display
NG image display screen
Initialize NG images

[1] How to register NG images

When the IV-C35M is used, select "YES" for NG image registration. NG images will be registered in the
controller's memory as they occur.
To make this setting, select "
See page 3-52.
NG screen setting procedure
On the "SELECT OBJECT TYPE COND" screen,
select "MEA-CND (CAMERA2)" and press the TRG/
BRT key. From the popup menu, select "NG IMGS"
and press the SET key.
When the message shown on the right appears,
press the SET key.
Reference page
1-17
Display when
an NG image 1-19 to 1-21
occurs
Display history 1-21
1-22
1-23
REGST NG IMG" on the [OBJ-TYPE SYS.] menu.
1-17
Setting and Operating Outline
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
+
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/0
OBJ-TYPE SYS.
TYPE(NEW)
=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
BY CHANGING A SETUP, THE CONTENTS OF SETTING IN A
CAMERA 2 WILL BE INITIALIZED. DO YOU CHANGE IT?
YES=SET, NO=ESC
COLOR F C1 BRT
OPS-MENU
SAVE
NG IMGS
1