Setting The Data Output; Select "Any" For The Serial Output - Sharp IV-C35M User Manual

Setting the Input/Output Conditions

21-7 Setting the data output

When you communicate with the IV-C35M using a computer link or a serial communication interface
(general purpose serial IF) in the following conditions, perform steps (1) and (2) below to enable serial
output.
- Computer link: When outputting any data
- Communication interface (general purpose serial IF): When executing a measurement run command
4 (processing code 14

[1] Select "ANY" for the serial output

Select "ANY" in the "
Setting (operating) procedure
1. Select "MAIN COND" -> "OBJECT TYPE
COND" -> "TYPE00" -> "OBJ-TYPE I/O" in
that order.
2. The "OBJ-TYPE I/O" screen will appear. Move
the cursor to "
the SET key. A popup menu will appear.
Select "ANY" and press the SET key.
21
Pages 23-3 and 23-4.
) and 4 (processing code 24
(H)
SERIAL OUTPUT" item on the "OBJECT TYPE I/O" screen.
SERIAL OUTPUT" and press
21-28
) Pages 22-8 and 22-10.
(H)
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ-TYPE SYS.
TYPE(NEW)
=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
OBJ-TYPE I/O SCREEN SAVE
1TRIG CCD START
BIN
2FILTER TYPE
RED
3CCD TRIG COND
(TO NEXT SUB-MENU)
4SHUTTER SPEED
1/00060 (1/30 1/10000)
5SERIAL OUTPUT
ANY
6CAM NO
1 (1 2)
7CALIBRATION
MANUAL
8CALIBRATION
(TO NEXT SUB-MENU)
=SELECT A MENU ESC=BACK SEL=CHNG IMG TRG=FUNC
1TRIG CCD START
2FILTER TYPE
3COLOR FILTER SET
4CCD TRIG COND
5SHUTTER SPEED
6SERIAL OUTPUT
7SET SERIAL BLOCK
8CAM NO
9CALIBRATION
0FILTER TYPE
qCOLOR FILTER SET
wCALIBRATION
ANY
BLOCK-ASSIGN