Sharp IV-C35M User Manual page 210

Point Measurement
POINT COND
Points which have been registered are marked with an "O."
- After being registered on the point condition setting screen, an "O" will be displayed in the
corresponding cells.
Setting the conditions (by selecting the point conditions)
How to enter the REG COND setting screen
This paragraph describes the setting for each point condition.
There are three ways to bring up the "REG COND" screen.
1) On the "MEA-CND" setting screen, move the
cursor to the "
the "AVG-GRAY" is selected on the
" MODE" line) and press the SET key. The
cursor will move into the table. Move the
cursor to the "X" column and press the SET
key.
Note: After being registered, the "X" mark in a
2) On the "MEA-CND" setting screen, press the
TRG/BRT key to move the cursor to the
upper function menu. Select the "COND" item
and then select the "REG COND" item and
press the SET key.
3) On the menu tree, move the cursor to the
"MEAS CND" item, and press the right arrow
key. The sub menu which contains the "REG
14
COND" item will appear. Move the cursor to
this item and press the SET key.
POINT COND" (
corresponding cell is changed to "O."
MEA-CND
, when
1
2BINARY PROCESS
3THRESHOLD
4
5
SET=
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ-TYPE SYS.
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
14-4
SCREEN COND SAVE RED F C1 DRK
IMG PRE-PROC
FIXED REG COND
SET [U.LM255 L.LM100(0~255)] EVALUATION
NUM-CALC
OUT
COLOR F C1 BRT
1SIZE
2EVALUATION
3EVAL-SPEC(RATIO %)
4REGISTER NO.
MEAS01(POINT-MEAS F)
IMG PRE-PROC
MEAS CND
REG-COND
EVALUATION COND
NUM-CALC
OUT-COND
POSI-CORRECT
MEAS(NEW)