Data Flow; Measurement Execution 1: Command Codes 10, 11, Or 12; Measurement Execution 2: Response Processing For Command 11 - Sharp IV-C35M User Manual

22-2 Data flow

The data flow between the IV-C35M and a personal computer is shown below.

[1] Measurement execution 1: Command codes 10, 11, or 12

æ
Select the measurement start input source = general purpose serial and parallel port
IV-C35M

[2] Measurement execution 2: Response processing for command 11

æ
Select the measurement start method = CCD trigger, parallel or serial output = general
purpose serial
Note: When a CCD trigger is chosen as the measurement start input, the sample start must be set
to parallel or auto.
IV-C35M
- You can specify the response block on the "OBJECT TYPE I/O" screen
æ
Select the measurement start method = CCD trigger, start sampling & output results =
general purpose serial
IV-C35M
1 Receiving a command
2 Transmitting a response
(measurement data, etc.)
1 Inputting a trigger
2 Transmitting a response
(Command 11,
measurement data, etc.)
1 Inputting a trigger
(Start sampling CCD trigger.)
2 CCD trigger
3 Transmitting
a response
(Command 11,
measurement data, etc.)
Communication (General Purpose Serial Interface)
Personal
computer
CCD camera or
programmable controller
Personal computer or
programmable controller
CCD camera or
programmable controller
CCD camera
Personal computer or
programmable controller
22-3
see page 21-25.
22