Mitsubishi Electric FR-A700 Instruction Manual page 7

Injury Prevention
b
CAUTION:
● Apply only the voltage specified in the instruction manual to each terminal. Other-
wise, burst, damage, etc. may occur.
● Ensure that the cables are connected to the correct terminals. Otherwise, burst,
damage, etc. may occur.
● Always make sure that polarity is correct to prevent damage, etc. Otherwise, burst,
damage, etc. may occur.
● While power is on or for some time after power-off, do not touch the inverter as it
is hot and you may get burnt.
Additional Instructions
Also note the following points to prevent an accidental failure, injury, electric shock, etc.
Transportation and installation
b
CAUTION:
● When carrying products, use correct lifting gear to prevent injury.
● Do not stack the inverter boxes higher than the number recommended.
● Ensure that installation position and material can withstand the weight of the
inverter. Install according to the information in the instruction manual.
● Do not install or operate the inverter if it is damaged or has parts missing. This can
result in breakdowns.
● When carrying the inverter, do not hold it by the front cover or setting dial; it may
fall off or fail.
● Do not stand or rest heavy objects on the product.
● Check the inverter mounting orientation is correct.
● Prevent other conductive bodies such as screws and metal fragments or other
flammable substance such as oil from entering the inverter.
● As the inverter is a precision instrument, do not drop or subject it to impact.
● Use the inverter under the following environmental conditions. Otherwise, the
inverter may be damaged
Operating Condition
Ambient temperature
Ambient humidity
Storage temperature
Atmosphere
Altitude
Vibration
Temperature applicable for a short time, e.g. in transit.
2.9m/s² or less for the 04320 or more.
FR-A700 EC
LD (150%), ND (200%, initial
value) and HD (250%)
SLD (120%)
FR-A740
−10°C to +50°C (non-freezing)
−10°C to +40°C (non-freezing)
90% RH or less (non-condensing)
−20°C to +65°C
Indoors (free from corrosive gas, flammable gas, oil
mist, dust and dirt)
Maximum 1000m above sea level for standard opera-
tion. After that derate by 3% for every extra 500m up
to 2500m (91%)
5.9m² or less (conforming to JIS C 60068-2-6)
III