Mitsubishi Electric HD-6000 Owner's Manual page 96

Appendix C: Remote Control Programming Codes,
continued
/MPORTANT
Some manufacturers may change their
products, or they may use more than one
remote controm system. If this is the case,
the HDTV receiver/contommer remote controm
may not be abmeto operate your VCR, DVD,
cabme box, satemmitereceiver, or A/V receiver.
After entering the correct codes in each position of
the remote control, use the slide switch to select
which product will respond when an operational
button is pressed. Only one of the below devices is
allowed for each slide switch position.
TV position:
Mitsubishi TVs
Cable/DBSiDTV position:
HD-6000 HDTV receiver/controller
NetCommand® controlled devices
DVD position:
DVD player
LD player
VCR position:
VCR
o
Audio position:
AiV receiver
DVD player
Cable box
If you have a Mitsubishi AiV receiver, the audio
position may be used in conjunction with select
Mitsubishi CD players. Your audio position must be
programmed to 010.
When your remote control has been programmed to
operate another manufacturer's product, the function
performed on each layer can vary. The most common
functions are:
VCR
POWER
CHANNEL up/down
PLAY
REC
PAUSE
STOP
FFiFWD
REWiREV
Mitsubishi VCRs will be compatible with some
additional buttons
Cabme Boxes and Satellite Receivers
POWER
CHANNEL up/down
0-9 number buttons (on some models)
ENTER (on some models)
CANCEL (on some models)
ADJUST up/down/left/right (on some models)
o GUIDE (on some models)
A/V Receivers
* POWER
VOLUME
MUTE
Mitsubishi A/V Receivers
Direct Input Selection buttons:
numbers, SQV and QV (on some models)
Mitsubishi CD Players
(not aimfunctions for aimmodels}
PLAY
FFiFWD
REWiREV
PAUSE
STOP
DVD and Laser Disc Players
(net all functions for all models)
POWER
MENU
0-9 number buttons (on some models)
PLAY
STOP
ARROW up/down/left/right (on some models)
FF/FWD
REWiREV
PAUSE
CANCEL (on some models)
ENTER
CHANNEL (on some models)
96