Finish Screen - Mitsubishi Electric HD-6000 Owner's Manual

NetCommand ® Initial Setup, continued
Note: if you selected "Other" for any of the
device names, the HDTV receiver/controller
can "Learn" the connected device by following
the Edit NetCommand instructions. For many
device types, nonqisted models will operate in
the same way as the listed models and you can
still use the pre-loaded setting.
Review Screen
Figure 4
After you have made your device choices the Review
Screen will display, it is important to review the
settings to ensure that they are correct, if necessary,
you can use <Back to return to the Device Setup
screen to make changes.
Finish Screen
Figure 5
To compiete the NetCommand setup, seiect Finish
from the Finish screen.
if you wish to change any of the pre-configured
inputs or names for the devices, or add devices not
in the pre-configured setup, seiect Edit to dispiay
Edit NetCommand menu.
if your A/V receiver was not listed, select Edit to
add the AVR and then assign all devices to new AVR
inputs.
Figure 5, Finish screen
Figure 4. Review screen
Note: The Review screen lists the HDTV received
controller input and A/V receiver input used with
each device. You must correctly identify the
inputs you used when you connected the devices.
If you have not connected your devices, write
down these inputs as a guide. If you cannot use
these inputs, or if you would like to change the
name of a device, use the instructions in Edit
NetCommand to make necessary changes.
Note: if you select Next> on the Review screen,
ai[ selections made are finaiized.
On the Review screen, adding or deleting check marks
wiii turn the adjacent devices, media cards or inputs
On or Off. 1394 device names only appear on the
Review screen when the devices are connected to the
TV.
Note: If TV Disc is not checked, TV Pause wiii
not be avaiiabie.
it is still necessary to memorize the available
channels for Antenna-1 (and Antenna-2, if used).
You may do that by going to the TV Main menu
and selecting Antenna. instructions to memorize
channels are found in the Antenna menu section.