Mitsubishi Electric HD-6000 Owner's Manual page 103

TroubJeshooting, continued
PossibJe SoJution
18. HD-6000 functions do not respond to the ®Use the System Reset button as explained at the end of this
remote control or to front panel control and will section.
not Power Off.
19. Name options not available for some channels _ Only memorized analog channels can be named.
20. When viewing a stopped VCR, white lines are
rolling on the screen.
21. HD-6000 turned itself Off and the Jight on the
front paneJ started to blJnk.
22n
23n
24n
When a Device is selected from the Device
Selection menu, the screen is blue
(no signal source).
The Device does not respond to button presses
from the remote.
The A/V Receiver is the selected audio source
but there is no sound.
25. The TV Speaker icon or A/V Receiver icon is
grayed out and not selectable.
26. Devices are grayed out in the Device Selection
menu or the PIP Selection menu.
27. Cannot see the A/V Receiver menu.
28. Screen is black when trying to view digital
channels or IEEE 1394 device.
®Turn off video mute for the VCR.
Begin playing the tape.
®Change the VCR input to the antenna input.
Momentary power fluctuation caused theHD-6000 to turn off to
prevent damage. Wait for the blue light to stop flashing and turn On
again.
If the HD-6000 does not stay turned On, use the System Reset
button. If this happens frequently, obtain an AC line power
conditioner/surge protecton
®Make sure the selected device is turned on.
®From the Edit NetCommand® menu select Review. Verify that
the inputs are actually connected to the HD-6000. If they are not,
either change the physical connections on the back panel, or select
the Change on the Edit NetCommand menu to change the
HD-6000 NetCommand's settings for the connection or connection
screen for each device.
Remote has not been setup for NetCommand ® use.
®The incorrect manufacturer was selected during setup.
Select the Change setting from the Setup menu and then the device
to display the manufacturer selection. Change if necessary.
®The device is not supported and keys have not been learned.
The requested function is not supported by NetCommand.
Verify that the function is supported or keys are learned.
®The IR emitter is incorrectly placed. Make sure the IR emitter is
facing the IR sensor in the device.
®The IR emitter is not plugged into the IR emitter Output
NetCommand.
®The IR emitter is facing the HD-6000, causing double signals. Be
sure that the IR emitter cannot send to the HD-6000.
®Check to see if the A/V Receiver power is turned on. After the power
is turned on, redisplay the Device Selection menu and press ENTER
to al!ow NetCommand to correctly select the A/V Receiver input.
®From the NetCommand Menu select Review. Check the Review
screen to see if the A/V Receiver inputs and device correspond to the
actual connections on the A/V Receiver. If they do not match, either
change the actual connections, or select Change on the Edit
NetCommand menu to change the input on the Connection screen.
®Select the Change setting from the Edit NetCommand menu, and
then select the device (for example VCR). Once the Connection
screen is displayed, check if the audio checkbox is selected for the
TV input and/or AVR input.
A recording is in progress requiring the use of Monitor Out. Cancel
the recording to select the device.
®Digital channels and media cards cannot display in the PIP or POR
The A/V Receiver is not connected to any input of the HD-6000. To
check the A/V Receiver menu temporarily plug into an unused input
of the HD-6000. Then select Review from the NetCommand Menu,
turn the input On to view the A/V Receiver menu.
® The PerfectColor rM color balance has been incorrectly set. Use the
Setup menu to reset the color balance.
103