E×Ternau Devices & Netcommand® Setup - Mitsubishi Electric HD-6000 Owner's Manual

Connecting E×temai Devices & NetCommand ® Setup
NetCommand is able to control many current audio and video devices by sending remote control signals from
the HDTV receiver/controller to each device through IR emitters, Additionally, it is also able to barn the remote
control signals used by most audio video devices not already in the HDTV receiver's memory, NetCommand can
automatically switch the HDTV receiver and compatible or learned Audio/Video (A/V) Receivers to the correct input
used with each device, It is important that the inputs on the HDTV receiver and AiV receiver back panels match the
NetOommand setup that is displayed on-screen,
To simplify the installation of NetCommand, there is a step-by-step on-screen NetCommand Setup procedure in this
chapter, which details the type and brands of devices you are connecting to the HDTV receiver, The NetCommand
Setup also assigns preset HDTV receiver and AiV receiver inputs for each device, You should connect each device
to the TV input (both audio and video) and to the AiV receiver (audio) as shown in the figure below,
Display monitor & connected speakers
Audio & Video output of device
AV RECEIVER
IR Emitters
_MonitorLink Control Cable is used only with Miteubishi display monitors
The following charts show which preset inputs you should use on the HDTV receiver and AiV receiver,
Chart 1 shows HDTV receiver inputs,
Chart 2 shows the AiV receiver inputs used by AiV receiver models already known by NetCommand,
Chart i
Device Audio and Video Outputs to HDTV R/C mnputs
Cable for CableOARD
TM
Service ANT-I
Antenna/Oabme (digital/anamog} ANT-I if primary viewing source,
ANT-2 if secondary viewing source
Cabmebox ANT-2
VCR lnput-f
Satellite Receiver (DBS) Input-2
DVD Player Component-i
Chart 2
Bose I DenenI I.tegra IKenweedIMarantzlPieneeri I pieneer21 ReteuI sew IYamahai_
After setting up NetCommand, you may go to the NetCommand menu at any time to change the inputs you used for
connecting each device, custom name devices, add devices not included in the presets above or delete devices no
longer used. See Helpfu! Hints, at the end of this chapter for additional information on device setup.
16