Netcommand® Menu; Netoommand® Menu - Mitsubishi Electric HD-6000 Owner's Manual

NetCommand® Menu
NetCommand Menu
Figure 11
Figure 11, NetCommand Menu
DetaiHed information regarding setting up and editing
the NetCommand menu is found in Chapter3. The Edit
NetCommand screens allow you to add new devices,
change or edit tradifionaH and IEEE 1394 devices, turn
devices and unused inputs On or Off, deHete a singHe
device or deHete the entire setup configuration. If you
choose to deHete the entire configuration, or if the
NetCommand setup was cancelled, deHeted or not
compHeted, you can start at the JnitiaHNetCommand
screen. The Review screen shows aH devices
connected to the HDTV receiver/controller.
Transport Menu
Figure 12
Note: Transport buttons (rewind, play forward, stop,
pause and record) on the remote control are located in
the bottom section of the remote control
DefauJt DigitaJ Record Device
If multiple digital recording devices are available in
NetCommand, this setting allows you to choose the
device to use when recording digital programs. A
digital recording can be made on either a digital or
analog device although the quality will not be as good
if recorded on an analog device. For best playback
quality, record digital programs on a digital recording
device.
If multiple devices were not connected and then
added in the NetCommand setup, this setting will
be unavailable (grayed out). Analog recordings can
only be made on the one analog device connected to
Monitor Out (usually a VCR) and are not affected by
this setting. This feature is most usdul when recording
from ChanneIView TM(page 59)_
icon Order
Figure !3
The Icon Order screen allows you to arrange the device
icon order on the Device Selection menu to a different
sequence, for ease of selection and operation. To change
the order, press ADJUST A ,V ,•, or • to highlight the
icon to be moved and then press ENTER. Press ADJUST
A ,V" ,• or • to move the icon to the desired position and
then press ENTER to release the icon.
Figure 12. Transport Menu
NetCommand uses the Transport menu to control the
TV Disc, VCRs, DVDs, IEEE 1394 AV Discs, digital VCRs,
and similar devices. If you choose to turn off this
menu when viewing the devices, the transport buttons
(rewind, play forward, stop, pause and record) on the
HDTV receiver/controller's remote control will continue
to operate these devices. In the Device Selection menu
selecting a VCR or DVD Hayer will automatically display
the Transport menu. You can re-display this menu by
pressing DEVICE MENU.
Select Transport menu functions by pressing ADJUST •
or • and then ENTER. For example, to pause playback,
press ADJUST • or • to move to PAUSE, then press
ENTER. If a function is not possible, such as record for a
DVD Hayer, the Transport menu button will be grayed ouL
Figure 13 Icon Order Menu
71