Netcommand® Controlled Recordings - Mitsubishi Electric HD-6000 Owner's Manual

NetCommand ® Controlled Recordings
Setting up Recordings
Figure !3
Through NetCommand, you can automatbaHy start
and stop recordings and send signais from one
piayback device to a recording device. Recordings
can be made on recordabb devices connected to the
HDTV receiver/controller or to the intemai TV Disc.
TheTV Disc is an JEEE 1394 hard disk drive, with 120
GB of memory and is avaiiabb for CabbCARD
TM,
Ant
1, Ant 2, JEEE 1394 or tuning devices (cabb boxes or
satellite receivers) connected to inputs 1 or 2 when a
PBPor POP is not dispiayed.
The HDTV receiver/controller can convert digital
channels and IEEE 1394 device signals to analog
signals that can be recorded on NetCommand
compatible analog VHS and S-VHS VCRs.
You can schedule the recording to take place at a
later time and program the recording duration for a
minimum of 30 minutes and a maximum of 6 hours
(in 30 minute increments). The default is 1 hour.
During the recording, the HDTV receivericontrolbr
can be powered Off. If the HDTV receivericontrolbr
is powered On, it must be tuned to the source that is
being recorded.
Figure 13 Record to screen
6O
Recording Now
Can be used when viewing Antenna 1 or 2, an IEEE
1394 device including TV Disc, or a non-recording
traditional device.
To initiate recording now:
1. Press REC (record) on the HDTV receiver/controller
remote.
2. Press DEVICE on the remote control to move to the
Source Device section.
3. Press ADJUST _ or _ to select the source device
you wiii record from. If a source is not displayed, it
is not available as a recording source.
4. Press ENTER to confirm selection and return to the
"Record to" section.
5. In the "Record to" section, review the destination
device and duration. Use ADJUST • or V to
change if necessary.
6. Press REC a second time to initiate recording.
Time-DeJayed Recording
To initiate a time-delayed recording:
1. Press REC (record) on the HDTV receiver/controller
remote.
2. Press DEVICE on the remote control to move to the
Source Device section.
3. Press ADJUST •, V, _ or _, to select the source
device you wiii record from.
4. Press ENTER to confirm your source device
selection and move to the Record to section.
5_
Press ADJUST _ or _ to select the Record to
device, duration time, start time (press ENTER
after selecting hour, minutes and AM or PM to set
the time) and day. For devices that can select
channels, select the channel.
6_
Select Add and press ENTER to add the recording
to the record lisL If your selection is successful, a
confirmation message wiii be displayed. If you pick
overlapping times, day(s), or destination devices,
you will see a message stating there is a conflict.
7. To exit, press HOME on the HDTV receiver/
controiier remote after aii recordings have been
added.