With Rgb, Hv Video - Mitsubishi Electric HD-6000 Owner's Manual

Connecting a DTV Receiver with RGB, HV Video
DTV Receiver with RGB, HV Video
Figure 13
A coaxial splitte_ RGB, HV and audio cables are required. These are not included with the HDTV receiver/controller.
1. Connect the outside antenna, came or sateHke to ANT or SATELLITE IN on the DTV receiver (see your DTV receiver
owner's guide for instructions and cabHe compafibiHRy).
2. Connect the incoming terrestdaH antenna or cabHe (not sateHRe) to ANT-1 on the HDTV receiver/controller back
paneH(a coaxiaH spHRter,avaiHabHe at most eHectronic suppHy stores, may be required to compHete this installation).
3. Connect RGB cables from the DTV receiver to Input-DTV on the HDTV receiver/controller back panel.
DTV Receiver to the BDTV receiver/controJJer Back Pane)
G (green) to Y/G
R (red) to Pr/R
B (blue) to Pb/B
4. Connect the H & V sync signals as shown below:
H (horizontal sync) to H
V (vertical sync) to V
All 5 cabies (G,R,B,H and V) must be connected. 3 cables or Sync on green connections are incomplete or not compatible and wiJJ
not work
5. Connect the L (left) and R (right) audio cables from the DTV Receiver to Input-DTV AUDIO on the HDTV receiver/
controller back panel.
DTV Receiver
(with RGB connections)
to antenns
2_ .1,
Figure !3. Connecting an External DTV Receiver with RGB Video Connections
it may be necessary to obtain a VGA to RGB, HV adaptor cable. These are available at most computer
stores and many electronic stores. Some of the adaptor cables have RCA type connector ends, others
have BNC type ends and will require adaptors as shown on p_ge 24.