Record List; Peer-To-Peer Connections; Peer-To-Peer Connectio Ns - Mitsubishi Electric HD-6000 Owner's Manual

Record List, Peer=to=Peer Connections
Record List
Figure 14
Press GUIDE while viewing the Record To screen to see a
list of all currently programmed recordings. A maximum of
32 recordings can be scheduled.
@_
Figure 14. Record List screen
OanceJ Current Recordings
To cancei a recording in progress, press DEVICE
to display the Device Selection menu and highlight
the source of the recording. Confirm that the icon
for VCR (or recording device) is in the Connection
Section next to the TV icon. Press the CANCEL
button. The icon for the VCR (or recording device) wiii
disappear from the Connection Section to confirm the
cancellation.
To cancel a recording on the Record List, press ADJUST
• or V to select the recording, then press CANCEL. To
page through the list, press CH • or V.
Peer-to-Peer Connections
A peer-to-peer connection allows the IEEE 1394 devices
in your HDTV receiver/controller network to talk to
each other without the further need of HDTV receiver/
controller intervention once the peer-to-peer connection
is established. For example, the HDTV receiver/controller
can set up a connection for an A/V Disc or DVCR that
sends a recorded program to an IEEE 1394 monitor in
another room. NetCommand will establish the connection
between the two devices. Once the connection has been
established, the HD-6000 can be turned off or be used
to display another device on the moniton Recording
from digital channels to a DVCR is also a peer-to-peer
connection. In this case, the HD-6000 is one of the
devices in the peer-to peer connection.
Setting up a Peer-to-Peer Connection
To establish a peer-to-peer connection:
1_ Press CONNECT on the HDTV receiver/controller
remote_
2. Press DEVICE on the remote control to move to the
Source Device section.
3. Press ADJUST _ or _ to select the source device
you wiii record from.
4. Press ENTER to confirm selection and return to the
"Record to" section_
5_ In the "Record to" section, review the destination
device (example: DVCR) and duration. Change if
necessary.
6_ Press CONNECT a second time to initiate
recording.
CanceJing a Peer-tooPeer Connection
After a peer-to-peer connection has been established,
you can cancel it by highlighting the source device
in the Device Selection menu. Confirm that the on-
screen icon for the peer-to-peer connection is in the
Connection Section next to the TV icon, then press
CANCEL The connection will end and the destination
icon will be removed. If there is more than one peer-
to-peer connection for the same device, all of the
connections will all be canceled.
NOTE: Multiple peer-to-peer connections can
occur simultaneously, sometimes with the same
source device.
61