Device Selection Menu - Mitsubishi Electric HD-6000 Owner's Manual

Device Selection Menu
When you press DEVICE on the HDTV receiver/controller's remote control, the Device Selection menu (Figure 7)
displays. If NetCommand@ has not been set up, the Device Selection menu allows you to select an input for viewing.
If NetCommand is set up, the Device Selection menu allows you to select the device for viewing, select audio from
the TV speakers or AiV receiver, power compatible devices On or Off, and verify the destination of signals. On the
Device Selection menu, the device or input currently displayed appears as a gold-colored icon.
Device
Section
Video Connection Audio
Section Section Section
Audio Section
When a NetCommand pre-memorized or learned IR
controlled AiV receiver has been connected to the
HDTV receiver/controller and added to NetCommand
Setup, an AVR icon wiii appear in the audio section.
Press AUDIO to change navigation to the audio
section. Then press ADJUST 4, •, • or • to select
the TV speakers icon or the AiV receiver icon. Press
ENTER to change the audio selection. Press DEVICE
to return the navigation to the Device Section.
Figure 7. Device Selection Menu with NetCommand
Power On/Off Devices
Devices that have separate On and Off remote control
buttons wiii power On automatically when you select
the device and wiii power Off when you turn off the
HDTV receiver/controller. For devices that do not
power On or Off automatically, display the Device
Selection menu, press ADJUST _ or • to highlight
the device icon and press POWER on the remote
control. For the A/V receiver, press AUDIO to move
the navigation to the Audio Section. Highlight the AiV
receiver icon and press POWER. If you press POWER
on the remote control when the Device Selection menu
is not displayed, the HDTV receiver/controller wiii turn
Off.
Device Section
To select another device or input, press ADJUST
4, •, • or • on the HD-6OOO's remote to move the
highlight. Press ENTER to select the device to view
and hear. The HDTV receiver/controller inputs are
automatically changed. If NetCommand is set up, the
inputs on compatible AiV receivers are automatically
changed at the same time.
If you're using a display with built-in or connected
speakers, use the display's remote control to mute
sound from the display's speakers. If you're using
the HD-6000 with the LT-4260 dispaly, muting occurs
automatically when the AiV receiver is selected
through NetCommand.
PIP Device SeJection Menu
Figure 8
The PIP Selection menu displays when you press the
PIP DEVICE button on the remote control. This menu
has the same general format as the Device Selection
menu. The source for the Video Section is the sub
picture and the Audio and Connection Sections are not
available.
Use ADJUST 4, •, • or • to move the highlight to
the device to show in the PIP or POP screen, then
press ENTER. Device icons that are grayed out are
not available for use as PIP/POP sources or with the
current source.
Video
Video Section
The TV icon shows the destination for the device
highlighted in the Device Section.
Device
Section
Connection Section
The Connection Section shows the other devices
currently connected to the device highlighted in
the Device Section. For example, if the Digital VCR
(D-VCR) is currently recording, when you move the
highlight to the Ant-1 icon, the D-VCR icon will appear
in the Connection Section. This icon will disappear
when you move the highlight to another icon, Press
CANCEL to stop recording.
Figure 8, PIP Device Selection Menu
has not _rovided that for the device.
57