Monitorlink Tmcontrol; Computer With A Pc Monitor Output - Mitsubishi Electric HD-6000 Owner's Manual

Connecting MonitorLink
TM
Contro or
a Computer with a PC Monitor Output
MonitorLink ControJ (For Use onJy with Mitsubishi DispJay Monitor with
MonitorLink ControJ Connection}
Figure 9
A MonitorLink control cable is required and is provided,
This connection allows the HD-6000 to automatically turn on or off the compaflMe MitsubisM dispHay monitor, When
used wth the Mitsubishi 4260 LCD TV, the connections allow the HD-6000 to use the remote control sensor in front
of the TV, Connect the MonitorLink control cable from the MonitorLink control on the HD-6000 back panel to the
M-Link control on the TV back panel (MonitorLink is also called MonLink or M-Link, depending on the Mitsubishi
display monitor),
You will also want to connect the MonitorLink HDMI Output to the Mitsubishi monitor, as shown on page 27 or 28_
Section detail of
Mitsubishi
]_/back pallel
Figure 9. Connecting M-Link Control
Computer with a PC Monitor Output
(Not for use when connected to the LT-4260 LCD TV)
Figure 10
A !5 pin PC monitor cable and an audio video cable is required, These are not included with the TV.
1_ Connect PC Monitor Out from the computer to PC Input on the HDTV receiver/controller back panel using a PC
compatible monitor cable, See Appendix B for PC signal compatibility,
2_ Connect the L (left) and R (right) audio cables from the computer to PC AUDIO on the HDTV receiver/controller
back panel, If the computer's audio output is a single mini-jack, a splitter is needed to complete this connection,
Note: The HD-6000 PC input is only compatible with VGA resolution (640 x480, 60hz), If your display monitor
is capable of a higher resolution then you should connect the PC directly to the monitor,
Note: To utilize the benefits of a digital A/V receiver, connect your computer's digital audio out, if available, to a
digital input on your digital AiV receiver,
Figure 10. Connecting a Computer with a PC Monitor
23